Balloon annotations have been improved in SolidWorks 2014, with several formatting and behavioral enhancements. Moving the arrow instead of the drawing view Selection of the geometry within a drawing view tells SolidWorks you want to move the entire drawing view. Normally, this is a great feature. However, there is one case that wasn’t supported as a … Continue reading “What’s New in SolidWorks 2014: Ballooning”
SolidWorks 2014 Beta testing is in full swing with SolidWorks users and VAR employees from all over the world are enjoying shooting the Beta bugs. Not only that, they are also competing with each other in various SolidWorks 2014 Beta Contests. So how about you? Have you join in the force for the Beta testing or still … Continue reading “Keep Shooting Bugs – SolidWorks 2014 Beta Week 2”
Tempted as I may be to spill the beans about planned SolidWorks 2014 enhancements based on what was shown at SolidWorks World 2013, I have to admit that Ricky Jordan’s article already covers them so well, I cannot really add anything more. Check out his very thorough coverage here: SolidWorks 2014 Sneak Peek
Here’s my looking-back slide show of SOLIDWORKS World 2014 in San Diego, CA. I’m now looking forward to SOLIDWORKS World 2015 in Phoenix, AZ!
DimXpert presentations seemed to get a lot of interest at SolidWorks World 2014. Both sessions I attended had full rooms. All The Uses of DimXpert, a Monday morning session by Josh Spencer of 3DVision Technologies was over flowing with interested attendees. Josh went into detail about what to use DimXpert for and how to use … Continue reading “DimXpert at SolidWorks World 2014”
